The IG-Rack Mount series is a relatively small EMC shielded space specially made for use in 19” test racks. The IG Rack Mount is easy to install and can be moved, if necessary, thanks to the modular subrack carrier. This space-saving solution is ideal for testing smaller devices such as IOT sensors. Features IG Rack…
Leadertech has an extensive line of suppression cores for suppressing of a wide range of unwanted frequencies and interference signals. There are versions with and without plastic housing, both in clamp and in ring version, suitable for round cables, flat cables or for clamping a bundle of cables. Ferrite materials: Type 28 Equipment- Broadband 10MHz-1GHz…
The Schlöder CDG 7000 is a test generator for all standards for immunity against conductive disturbances caused by high-frequency fields. It is one of the few combined IEC 61000-4-6 test systems that combines an RF signal generator, RF power amplifier, three-channel RF voltmeter and directional coupler in one device. The IEC standard describes a test…
Servometer bellows are metal spring-like components engineered with the highest precision. These are intended to accommodate movements, both lateral and axial, of hermetically closed seals. This can be mechanical movements or shocks, but also movements caused by large temperature differences. Bellows can also be filled with a liquid or a gas. Servometer has a wide…
The Ranatec RI 3101 Butler Matrix is a beamforming network which typically is used to feed a phased array of antenna elements. It controls the directions of a beam, or beams, of a radio transmission. The beam direction is controlled by switching power to the desired beam port. The RI 3101 Butler Matrix is designed…
Com-Power’s preamplifiers are used by EMC laboratories to improve the sensitivity of the test system during emission measurements. Without these preamplifiers. signals below the lower limit of the test system will not be measured. The gain from the preamplifier provides minimal distortion over the entire frequency range for accurate measurements. Com-Power has several versions that…
As a manufacturer of RF and microwave amplifiers, CPC Power Amps has developed a special series for MRI scanners. There is a range of low to high power single channel versions as well as a multi-channel family. The latter has been specially developed for parallel transmitter applications (B1 shimming). The multiple channels of the matched…
In addition to USB2.0, Ranatec also has pass-through filters for USB 3.0. The Ranatec RI 4192 USB 3.0 Superspeed Feedthru Filter has a minimum of 50dB filter suppression at 0.7-6 GHz, 2A filtered power throughput and the filter can be switched on and off via USB. It fits in the same recesses as the other…
Exodus Advanced Communications MPA3013 offers a new millimeter wave, medium power amplifier module that covers the frequency range 26.5–40.0GHz. The minimum gain of this 1W linear class A amplifier module is 36dB typical. Exodus mainly focuses on RF applications in EMC and test applications within aerospace and the military market. Their product range covers amplifiers…
Metal PCB shields are used to shield parts of a printed circuit board against EMI / RFI influences. For larger volumes, mounting with a pick & place robot is desirable. Leadertech has a PCB shield series with a removable pick spot, so that access to the component is still possible after installation. Leadertech has many…
